If an error occurs, or the ink lever is at the up position, you try to print a test pattern (nozzle check, status check, head alignment, or paper thickness pattern) from the SelecType settings.Īfter 3 seconds the message disappears. Push the paper lever down to remove the paper. Loaded paper is too thick for head cleaning. Start printing again from the beginning for best results. Set the paper lever to the secured position. Paper lever was released during the printing process or another operation. See Troubleshooting on the Optional Auto Take-up Reel Unit. Optional Auto Take-up Reel Unit is not operating correctly.Ĭheck whether the unit is operating correctly. Paper is set out of the horizontal cutting area.Ĭut the paper at the paper insertion slot, then reload paper. Remove then reload the paper so that the right and bottom edges are straight and in line with the rows of punch holes on the printer. Paper could not be reversed into the printing position. See Paper Feed or Paper Jam Problems Occur Frequently. Slippage occurred and paper was fed at an angle. When RELOAD PAPER is displayed, load paper.
See also Paper Feed or Paper Jam Problems Occur Frequently.Ĭut the paper manually, then remove the cut paper from the printer. Make sure the paper source setting in the printer driver is the same as the control panel. The paper source setting in the printer driver is different from the control panel. If this message appears during a print job, reset the printer by pressing the Pause button for 3 seconds, then load paper and send the job again. Remove any printouts or paper remaining in the printer.
0 kommentar(er)
